The switch now runs this default configuration. Save this configuration to nvram and exit.Ĭhoose (2) to save the configuration to NVRAM to use it the next time the switch reboots. Return back to the setup without saving this config. Go to the IOS command prompt without saving this config. The following configuration command script was created:Įnable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1įrom these choices that appear, make your selection and press Return. This is an example of the configuration output that appears: You have now completed the initial configuration of the switch. Would you like to enable as a cluster command switch? : no You can configure the switch as a command switch later through the CLI, Device Manager, or the Network Assistant application. If you enter N, the switch appears as a candidate switch in the Network Assistant GUI. Enter N to configure it as a member switch or as a standalone switch. Subnet mask for this interface : 255.0.0.0Įnter Y to configure the switch as the cluster command switch. IP address for this interface: 10.4.120.106 The IP address and subnet masks shown are examples.Ĭonfigure IP on this interface? : yes Management network from the above interface summary: vlan1Ĭonfigure the interface by entering the switch IP address and subnet mask and pressing Return. For this release, always use vlan1 as that interface.Įnter interface name used to connect to the To configure SNMP later, enter no.Ĭonfigure SNMP Network Management? : noĮnter the interface name (physical interface or VLAN name) of the connection to the management network, and press Return. You can also configure SNMP later through the CLI, Device Manager, or the Network Assistant application. (Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. To configure the country code, enter yes and press Return.ĭo you want to configure country code? : yesĮnter the country code, and press Return. The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores leading spaces.Įnter virtual terminal password: terminal-password The secret password is encrypted, and the enable password is in plain text.Įnter an enable password, and press Return.Įnter a virtual terminal (Telnet) password, and press Return. The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive, allows spaces, but ignores leading spaces. Do not use -n, where n is a number, as the last character in a host name for any switch.Įnter an enable secret password, and press Return. On a command switch, the host name is limited to 28 characters on a member switch the name is limited to 31 characters. Would you like to enter basic management setup? : yesĮnter a host name for the switch, and press Return. To configure each interface on the system. Use ctrl-c to abort configuration dialog at any prompt.ĭefault settings are in square brackets ''.īasic management setup configures only enough connectivityįor management of the system, extended setup will ask you Would you like to enter the initial configuration dialog? : yesĪt any point you may enter a question mark '?' for help. If your switches are stacked and there are multiple console connections to individual switches in the stack, the initial setup dialog box appears at the console where you first press Enter.
0 Comments
Leave a Reply. |